Maintain Your Car's Fluid Levels
This article used in it's entirety is written by Scott Memmer
|
|||||
Checking your oil level is a fairly simple procedure. Experts generally agree
that it's best to drive the car first before checking it. So take a little spin,
then find a cool, shady spot to pop the hood.
Let the car sit for at least five minutes before checking, to give the oil time
to settle into the sump.
With the hood open (and securely propped, so it doesn't bonk you on the head),
locate the dipstick. It will be near the front of the engine, close to you, and
sometimes has a brightly colored handle -- yellow, red, or some other noticeable
color. Find it? OK, remove it and wipe it with a clean rag or towel. Reinsert it
into hole, then slowly remove it again. Check the level. The oil mark should
fall between the two hash marks on the dipstick. If it's below the lower level,
you need to add oil -- a quart will usually do it. Before you do so, though,
wipe the dipstick again and check it a second time. Still low? Add a quart and
recheck it. (It's best to add the oil, then start the engine to circulate it,
then let it sit for another five minutes before rechecking.) If it's still below
the lower hash mark, you may need to add another quart, but be careful not to
overfill it, as this can lead to other problems. Automatic
Transmission/Transaxle. The automatic transmission fluid should be checked
with the engine running. The transmission dipstick is typically located behind
the oil dipstick, and doesn't stick up as high. If you have trouble locating it,
consult your owner's manual. Oftentimes it will have the same colorful markings
(yellow, red, etc.) as the oil dipstick.
Start the engine and locate the transmission fluid dipstick. Before you do,
though, make sure to remove any loose clothing hanging from your neck, such as a
scarf, sweater, necktie, or long jewelry. These could get caught in a running
fan belt and cause you to have a close encounter of the mechanical kind.
With the engine running, extract the transmission dipstick. Wipe it clean and
reinsert it, then extract it again. It will have similar markings to the oil
dipstick, one mark for too low, another for too high.
(Note: Transmission fluid will almost never be low. The automatic transmission /
transaxle is a sealed system, requiring little maintenance. If your fluid is
low, it most likely means you have a leak in the system, such as a worn seal or
a crack somewhere. Have you noticed an oily patch on your driveway where you
park? Is it red, or reddish-brown? If so, you may have a transmission leak and
will need to see a mechanic.)
Even if the level is OK, note the color and consistency of the fluid. If it is
very dark or black, check your records and owner's manual and plan on getting it
changed; it's probably overdue.
Manual Transmission. This is done with the engine off. For most cars, you
have to get under the car and remove the fill plug with a wrench. Stick your
finger in and feel for fluid. If you can feel fluid on the tip of your finger,
it's probably OK. Again, as above, note the color of the fluid and consult your
owner's manual for exact procedures and service interval.
Radiator/Cooling System. This should be done when the engine is cool or
lukewarm, not cold.
Please note: The contents of the radiator are pressurized and can scald you
if the system is opened when it is hot. Also, never check the radiator when
the engine is running.
Locate the radiator cap. It should be in the center of the engine compartment,
in the very front. Use a rag to remove it. Look down into the radiator and see
if you can spot fluid. If it's near the top, you're in good shape. If not,
you'll need to add some.
Engine coolant is added on a 50/50 basis -- 50 percent water, 50 percent
coolant. Read the instructions on the coolant container for details.
You may want to also check the fluid level in the coolant reservoir. This is a
plastic container just to the side of the radiator, with a hose connecting the
two. It serves as an overflow receptacle for excess radiator coolant (since the
fluid expands and contracts with heat). Pop the lid open and fill it about
two-thirds of the way full.
Brakes. Like the transmission, the braking system is a sealed network. If it
repeatedly gets low on fluid, you need to locate the source of the problem,
either by yourself or with the help of a mechanic. A leaky braking system is
nothing to play around with.
To check the fluid level, locate the brake fluid reservoir. It's usually in the
engine compartment. If you can't find it, consult your owner's manual. Remove
the lid and check the level. It should be at least two-thirds full. If not, fill
to the "full" line with brake fluid.
Note: Avoid getting water in the braking system, at all costs. Therefore, do
not do this procedure in the rain, unless in a garage or under an overhang.
Battery. Some cars have what is called a "maintenance-free battery." This
means the battery is sealed and should not be tampered with. You'll be able to
tell right away, since the battery has a flat top with no openings.
Most cars, however, still utilize traditional battery design, with six cells
that need occasional refilling. Access to the cells comes through six screw
caps, or, more commonly these days, two rows of plastic caps that pressure-fit
over three cells each. Either pry the caps off with a flat-head screwdriver, or
unscrew the six caps.
It's best to fill battery cells with distilled water, since it lacks
contaminants and trace elements that can cause a corrosive buildup around the
battery terminals.
The battery cells should be filled to the bottom of the fill hole, no further.
CAUTION: Battery acid has sulfuric acid in it, which is highly caustic to
skin and eyes. Wear eye protection and gloves when doing this procedure.
|
|||||