How To Properly Install  Custom Auto Seat Covers
Written by Elena Maria Inc.
 

Free use of this article is permitted, provided it is used
in it's entirety including the embedded link.

Here are tips on installing 2 piece (top and bottom) a custom bench
seat auto seat cover:

Remove the seat from the vehicle and then remove the back rest. Fit
section marked “back” to back rest. Line up base pattern to the pattern
on the back rest if any. Secure all elastic straps with supplied “S” hooks
Replace rear back rest and rear base. Check that auto seat covers are
secure, that auto seat covers are fitting correctly, and that all pattern match.

Here are tips on installing bucket seats:

Remove any guards of shields covering original material. Tie three string
provided to bottom seat cover flap. The string attach to loops on the flap.
Place bottom seat cover on the seat and align the seam in the seat cover
with the edge of the seat. Tuck the flap and three strings between the top
and bottom of the seat. Gather string and pull tight. Feed the string beneath
the seat. If there is a wire beneath your seat, ensure that the string go above
it and they do not interfere with the movement of the seat.

Each string will attach to a corresponding loop in the front. The easiest way
to do this is to take string through a loop twice, pull the string tight, then
make a cinch knot. Repeat fro each string. You want to get these as tight as
possible. Take the string (string that comes attached to cover) below and
behind any mechanism. Both sides are brought around to the back where
they are tied off tight. Place guards and shield back on. If headrest are
present, remove the headrest. Tie three string provided to top seat cover.
The string attach to loops on the flap. Pull top cover down tight over the
seat. Fold and tuck the edges. F Feed three strings and the material through
between top and bottom of seat. Pull each string tight and tie it to it’s
corresponding loop underneath the material. If headrest were present,
replace headrests. Each string