Car, truck, SUV,
mini van,, antique and classic or limousine cover fabric are made specifically
to be used for indoor or outdoor protection.
Indoor car cover fabrics for vehicles stored inside are designed to protect your
vehicle’s paint finish against scratches, dirt and the accumulation of dust.
Tan Poly cotton, 1 layer polyester and cotton blend
Form Fit , 2 layer polyester and lycra, spandex with and 100% cotton terry loop.
Tan Flannel, 2 layer polyester and poly cotton blend with a 100% cotton
interior layer.
Dust top,4 layer outer polypropylene and polyethylene composite, polypropylene
middle lay and polypropylene and polyethylene inner layer. Available in taupe.
Car, truck, suv, mini van, limousine antique and classic, limousine cover fabric
are made specifically to be used for outdoor protection.
Outdoor truck cover fabrics for vehicles stored outdoor are designed to protect
your vehicle’s paint finish against scratches, dirt, accumulation of dust, air
born pollutants, smog, grime, tree sap, flying debris (tree branches), UV rays
and bird droppings.
Weather shield, for climates with lots of rain, 3 layer patented immersion
encapsulate coats the polyester fabric barrier within woven polyester fabric,
long lasting protective formula inside the fabric. Available in: black, bright
blue, gray, green, red, sky blue, taupe.
Noah for climates
with climates with a little rain , 3 layer, polypropylene fabric, outer layer
door breathable inner layer film, polyethylene and nylon inner layer.
Available in silver gray.
Evolution 4 for climates with lots of snow and sub zero temperature, 4 layer non-woven polypropylene fabric. Available in : blue, gray , tan.
Multibond for climates hot and no rain climates, 3 layer polypropylene fabric,
Available in gray.
Sunbrella, for sunny and intense climates 1 layer acrylic woven marine use
fibers fabric.
Available in: pacific blue,
cadet gray, jet black, sky blue, toast.
The generic cleaning instructions noted below are intended for use with all car
covers but you should refer to the instruction sheet enclosed with the car cover
for any fabric specific care instructions.
Car cover fabric
performance can be severely affected by dirt that builds up on and within the
material. It can cause the windshield and paint to become dirty and “fogged” as
well as create “wicking” where it actually helps pull water through the fabric,
nullifying any water resistant properties the fabric may have had. Cleaning your
cover will help to keep your vehicle clean and to increase the service life of
the cover.
NEVER...Clean a car cover in a washer with a center agitator except
weathershieldd® fabric covers).
NEVER...Use fabric softener.
NEVER...Dry a non-woven or specialty type cover in a dryer.
(WeatherShield® fabric & Form-Fit™ covers can be dried in a dryer with regular
heat; polycotton, cotton and flannel can be dried on low heat.)
1 - Using a large commercial washer without agitator, wash the cover using 1/4
cup of Simple Green All-Purpose Cleaner (some WeatherShield covers are compact
enough to be washed in a normal size washer). Put the cover in the washer and
pour the cleaner in the tub after it’s filled with warm water or pour it
directly in the machine (some wall mounted commercial units), then put in the
cover and start the machine .
2 - Rinse the cover twice (2X) to remove all the cleaner.
3 - Air dry (unless it’s one of the covers noted above that can be dried in a
dryer with regular or low heat).
A cover may also be cleaned by turning it inside-out on the vehicle.
1 - Mix one ounce Simple Green All-Purpose Cleaner per quart of warm water.
2 - Spray or sponge onto cover.
3 - Rinse with plain water (until no suds) and allow to air dry.
Elena Maria Inc. is the creator of Auto Product Articles Library, articles that have helpful, useful and necessary information to help in choosing the right custom made automotive accessory the first time. http://www.caraccessories.com/carcovers.asp